Uganda Corn Dryer Machine For Sale 45 Tons China Corn Dryer Seller

INTRODUCTION-GRAIN DRYER
1. The incoming materials enter the dryer through the elevator.

2. Batch loading of grain that can be carried, after the warehouse is full, the limit full grain meter sends back the full warehouse alarm signal, close the elevator grain input plug plate to stop loading.

3. Click the automatic drying button on the PLC smart panel, and the dryer will start the program according to the pre-set sequence and enter the drying working state.

4. Press the electronic start button of the heat source (only available when fuel oil or gas), and the hot air furnace begins to enter the combustion and heating state. Ensure that there is enough fuel to use.
When burning biomass pellets or coal and wood, the initial use of the furnace temperature will rise slowly, and the clean hot air generated will be brought into the dryer through the negative pressure fan for grain drying.

5. The grain is delivered by the elevator and circulates inside the dryer.
The dry hot clean air entering the dryer is transmitted through the corner box to exchange moisture and heat with the grain, and is converted into water vapor and discharged by the dehumidification fan.

IS IT ESSENTIAL TO INSTALL GRAIN DRYER MACHINE FOR YOUR MILL?

Definitely Yes,Cause...
1)Full time processing ability,get rid of bad weathers' interruption,like raining,storm,snowing and etc
2)Massive Drying Capacity,one batch could reach 20 tons capacity,if connected with 5 sets,100 tons per day is available
3)Low-cost running consumption,Biomass material/coal/gas/diesel are all available
4)Flexible installation method,one furnace could connect 3 to 4 dryers,to save the land space
5)High processing efficiency,mo blind drying section,all the material would keep to the same mositure rate,make them the same quality
6)Slow and careful auger,tiny broken and waste material during the circulation
7)Best return on Investment ratio,running one to two month,could get back the investment on the machine
 
TECHNICAL PARAMETERS

 
 
 
 
 
 
 
 
 
 
 
                                                      Furnace Burner Options

What We Can Offer

1)Whole turnkey project solution
included Pre-cleaning machine,elevator,input&outlet pipe,furnace and dryer
2)Plant designition service
supply you all the possibly area required,the instllation diagram for consideration
3)Instllation and commisioning service
professional engineer woud guide you for the assembling and commisioning the machine
4)Full time online service
24 hours online technique service,ensure to tackle the problem immediately
5)Enormous spare parts to support
easy broken spares and wearing parts would be send timely,no worry for drying season

Drying Unit Diagram

 
Applicantion: